Cleaning Electrostatic Furnace Filters

Posted on

Cleaning Electrostatic Furnace Filters

Comprehensive Mold Management is an official dealer of Electrostatic Furnace Filters that last a lifetime. We offer a variety of filters to fit whatever you are looking for in your home. Our standard filters are undercut by 3/8” from the size listed. Always keep in mind you should allow for 1/8” overall manufacturing tolerance. Custom filters are cut to the exact measurements that are entered when you are ordering online.

We also offer 3 types of filter frames; Gold, Silver and Flex. Our Gold frame is a gold anodized extruded aluminum frame that consists of 4 separate pieces fastened together by a screw in each corner.  These filters only come in a 1″ depth. Our Silver frame is made of a single piece of roll-formed aluminum riveted together at each corner.  It slightly less strong and sturdy as the gold frame but, it is more cost effective.  These filters can be purchased in ½”, 1″, or 2″ depths. Our 3rd option is the Flexible filters which are not made with aluminum frames but rather sewn with flexible polypropylene webbing around the edge.  This allows for use in tight fitting areas where bending the filter might be needed to get it installed.

Here are a few easy steps for cleaning the filter which should be done about every 4 weeks:
·         Simply remove the air filter
·         Flush with water in opposite direction of air flow arrows then rinse other side.
·         Spray with ZAP! CLEANER to remove stubborn stains.
·         Rinse thoroughly to remove remaining dirt.
·         Drain excess water.
·         Dry out thoroughly before re-installing.

Following these steps will make sure the filter is kept in good working order.

Post a Comment